Rockwell Automation 1766-L32 Pump Station Controller Quick Start - Manual (Page 25)

Publication IASIMP-QS037A-EN-P - May 2013 23
Chapter 1
– Press Pump Statistics to open the Pump Statistics screen. Refer
to Pump Statistics Screen on page 23. The Pump Statistics button is
only visible after an application has been assigned
– Press PID Tuning to access the PD Tuning screen. Refer to PID
Tuning Screen on page 24. The PID Tuning button is visible only if
Pressure Follower mode is selected
– Press PanelView Config to close the running PanelView application
and open the PanelView configuration screen
Pump Statistics Screen
From the Pump Statistics screen you can:
– Select a pump to view the statistics for that pump. The number of
pumps visible depends on how many are in use. The flow totalization
is only visible if digital input I:0/0 is set to totalize or if analog input
I:1.1 is set for flow
– Reset the run time and cycle count (shown in yellow)
– View the motor current and voltage if a PowerFlex series 4 VFD is in
use
– View the flow totalization, if digital input I:0/0 is set to totalize or if
analog input I:1.1 is set for flow