Rockwell Automation 1766-L32 Pump Station Controller Quick Start User Manual
Page 32
30
Publication IASIMP-QS037A-EN-P - May 2013
Chapter 1
appear at the top of the list. Alarms remain in the list until the Clear All
Alarms button is pushed on the maintenance screen.
Because this list contains past alarms (history), use the UP/DOWN and
PAGE UP/PAGE DOWN buttons to scroll through the list.
From this screen you can also:
– Press View Warnings to go to the Warning screen. Refer to Warning
– Press Alarm Output Config to go to the Alarm Output
Configuration screen. Refer to Alarm Output Configuration on
page 32.
– Press View VFD Alarms to view PowerFlex 4 alarms, if a PowerFlex
4 VFD is being used. Refer to VFD Faults (PowerFlex 4 VFDs only)
on page 31.
List of available alarms:
System Interlock I:0/19 Not Energized
Pump #2 Failed To Run
High Level
PowerFlex VFD #2 Comm Loss
Low Level
Pump #2 OL Tripped/VFD Fault
High Pressure
Pump #2 Over Temp
Low Pressure
Pump #2 Seal Fail
Analog Input I:1.0 Out Of Range
Pump #3 Failed To Run
Analog Input I:1.1 Out Of Range
PowerFlex VFD #3 Comm Loss
Power Failure
Pump #3 OL Tripped/VFD Fault
Generator Running
Pump #3 Over Temp
Generator Fault
Pump #3 Seal Fail
General Fault
Pump #4 Failed To Run
Pump #1 Failed To Run
PowerFlex VFD #4 Comm Loss
PowerFlex VFD #1 Comm Loss
Pump #4 OL Tripped/VFD Fault
Pump #1 OL Tripped/VFD Fault
Pump #4 Over Temp
Pump #1 Over Temp
Pump #4 Seal Fail
Pump #1 Seal Fail