Rockwell Automation 1766-L32 Pump Station Controller Quick Start - Manual (Page 11)

Publication IASIMP-QS037A-EN-P - May 2013 9
Chapter 1
3. Press Next to proceed to the Motor Control Setup screen. In the
example shown, four pumps have been configured; the screen will only
display as many pumps as you set up in the initial configuration screen.
From the Motor Control Setup screen you can use the Up/Down
buttons to select the pump control device.
The Starter and Other VFD selections use physical outputs from the
PLC to control the start/stop operation of the motors, while the
PowerFlex 4 option uses Modbus communication to control the VFD.
4. Press Next to proceed to the first Digital Inputs Assign screen. There
are four Digital Inputs Assign screens in total.
From the first Digital Inputs Assign screen you can:
– Use Digital input I:0/0 as a pulsed input to totalize flow only or to
totalize flow and calculate a flow rate.