1 - prepare the powerflex 70 drive hardware, Before you begin, Chapter 1 – Rockwell Automation Logix5000 Control Systems: Connect a PowerFlex 70 Drive over DeviceNet Quick Start User Manual
Page 13: Prepare the powerflex 70 drive hardware, Prepare the powerflex 70, Drive hardware, Chapter
Rockwell Automation Publication IASIMP-QS030A-EN-P - July 2012
13
Chapter
1
Prepare the PowerFlex 70 Drive Hardware
In this chapter, you learn how to complete the following tasks:
•
Mount and wire power to a PowerFlex 70 drive.
•
Set the DeviceNet communication card’s operation mode, node address, and
communication rate.
•
Connect the communication card to the drive.
•
Connect the communication card to the network.
Before You Begin
Before you begin, complete these tasks described in
Before Using This Publication on page 5
•
Prepare the Logix5000 control system hardware
- Verify the control system and the
DeviceNet network are powered.
•
•
•
Create an RSLogix 5000 project
- The example RSLogix 5000 project used in this quick
start uses a CompactLogix 5370 L3 controller.