Rockwell Automation Logix5000 Control Systems: Connect a PowerFlex 70 Drive over DeviceNet Quick Start - Manual (Page 48)

48 Rockwell Automation Publication IASIMP-QS030A-EN-P - July 2012
Chapter 3 Use a PowerFlex 70 Drive in an RSLogix 5000 Project
Test the PowerFlex 70 Drive Tags
1. Move the controller’s mode switch
to the RUN position.
2. In the configuration tree, double-
click Controller Tags.
3. Change the
O.CommandRegister.Run tag to 1.
The 1769-SDN scanner module
transitions to Run mode.
4. If you receive a fault message on
your PowerFlex 70 drive, press
on the keypad to clear
the fault.
RUN
REM
PROG