Rockwell Automation Logix5000 Control Systems: Connect a PowerFlex 70 Drive over DeviceNet Quick Start - Manual (Page 19)

Rockwell Automation Publication IASIMP-QS030A-EN-P - July 2012 19
Prepare the PowerFlex 70 Drive Hardware Chapter 1
Connect the Drive to the DeviceNet Network
1. Remove a knockout from the
bottom plate on the drive.
A hole is created at the bottom of
the drive through which you can
route a connector cable.
2. Connect the 1799-DNC5MMS
5-pin linear to micro male adapter
to the female end of the 1485K-
P1F5-R5 KwikLink right-angle
micro male to micro female
connector cable.
3. Route the connector cable
through the hole in the bottom of
the drive and connect it to the
DeviceNet connector on the
adapter.
Knockout