Rockwell Automation Logix5000 Control Systems: Connect a PowerFlex 70 Drive over DeviceNet Quick Start - Manual (Page 15)

Rockwell Automation Publication IASIMP-QS030A-EN-P - July 2012 15
Prepare the PowerFlex 70 Drive Hardware Chapter 1
Mount the Drive
For the purpose of this quick start, the PowerFlex 70 drive can be propped in a safe and
convenient location.
For complete mounting instructions, see the PowerFlex 70 Drive User Manual, publication
20A-UM001 .
Wire Power to the Drive
1. Loosen the screw and remove
the cover.
2. Verify that a jumper is installed
between I/O terminals 7 and 8.
3. If there is no jumper between I/O
terminals 7 and 8, install one
before proceeding.
WARNING: Verify that all incoming power is turned off before wiring power.
Do not apply incoming power before connecting the DeviceNet adapter to the drive.