Rockwell Automation Logix5000 Control Systems: Connect a PowerFlex 70 Drive over DeviceNet Quick Start - Manual (Page 26)

26 Rockwell Automation Publication IASIMP-QS030A-EN-P - July 2012
Chapter 2 Create DeviceNet Network Software Files
Set the 1769-SDN Scanner Module’s Node Address
This quick start describes how to use a PowerFlex 70 drive in a CompactLogix 5370 L3 control
system over a DeviceNet network. The computer is connected to the controller via an
EtherNet/IP network, and the controller accesses the drive on the DeviceNet network via a
1769-SDN scanner module installed in a local expansion module slot.
To complete the steps described in this chapter, the scanner module uses the DeviceNet network
node address 0:
• If your scanner module’s node address is already set to 0, you can skip this section and move
to
Create a DeviceNet Configuration File on page 29 .
• If your scanner module’s node address is not set to 0, use this section to learn how to change
it from its current value. For example purposes, the scanner module’s node number is 3
before it is changed.
1. Verify the controller’s mode switch
is in the PROG position.
2. Start RSNetWorx for
DeviceNet software.
IMPORTANT The tasks described in this section require the use of the Node Commissioning tool in RSNetWorx for DeviceNet
software. If you are using RSLogix 5000 software, version 20 or later, as required with this quick start, the Node
Commissioning tool was an optional choice during the software installation.
If you did not install the Node Commissioning tool previously, do so now.
RUN
REM
PROG