Hapter, Installing the serial converter – Rockwell Automation RECOMM-232 Serial Converter for use with DPI AC Drives User Manual
Page 15
Installing the Serial Converter
3-1
C
HAPTER
3
Installing the Serial Converter
Chapter 3 provides instructions for installing and removing the serial
converter.
3.1
Selecting Cables
The following cables are all you should need to connect the serial
converter to a product and computer.
Important:
To provide proper termination of the serial cable
shield, the computer chassis should be properly
grounded. If it is not possible or practical to ground the
computer chassis, then a ground wire should be
connected to the serial cable shield at the shell of the
9-pin sub-miniature D-connector.
#
Description
Part Number
1
DPI cable to connect the serial
converter to a drive.
RECBL-M10
2
Serial cable to connect the serial
converter to the computer.
RECBL-SFC
Figure 3.1 – Cables
1
2