Rockwell Automation RECOMM-232 Serial Converter for use with DPI AC Drives User Manual
Page 40
B-4
Serial Converter for use with DPI AC Drives
Number of ENQ characters sent by the serial converter.
Number of ENQ characters received by the serial converter.
Number of NAK characters received by the serial converter.
Number of NAKs sent by the serial converter because of corrupt
packets (improper protocol messages) as determined by the serial
converter.
Number of NAKs sent by the serial converter because it did not
have sufficient memory to buffer the incoming messages. The serial
converter runs out of memory if a command has not completed and
there is no place to save the new commands.
1
This value is normally a low value. If it is continually incrementiong and you
are having communications problems, use a lower baud rate or replace
the RECBL-SFC serial cable.
10
ENQs Sent
1
Range:
0 to 65535
Default:
0
Type:
Read Only
11
ENQs Received
1
Range:
0 to 65535
Default:
0
Type:
Read Only
12
NAKs Received
1
Range:
0 to 65535
Default:
0
Type:
Read Only
13
NAK Bad Packet
1
Range:
0 to 65535
Default:
0
Type:
Read Only
14
NAK No Memory
1
Range:
0 to 65535
Default:
0
Type:
Read Only