Rockwell Automation RECOMM-232 Serial Converter for use with DPI AC Drives - Manual (Page 25)

Configuring the Serial Converter 4-9
4.4.3 Resetting the Serial Converter
After you change some parameters, you must reset the serial
converter for the new setting to take effect. You can reset it by
removing and then reapplying power or by using Reset Module (05).
To reset the serial converter, set Reset Module (05) to either Reset
Module or Set Defaults. “Reset Module” will reset the serial
converter. “Set Defaults” will set all parameters in the serial
converter to their factory-default values. Refer to figure 4.9.
After you enter the “Reset Module” value, the serial converter will be
reset. This parameter will then be reset to “Ready.”
!
ATTENTION: If the serial converter is transmitting
control I/O to the product (indicated by a solid green
diamond LED), the product may fault when you
remove or reset the serial converter. Determine how
your product will respond before removing or
resetting a connected serial converter. Failure to
observe this precaution could result bodily injury
and/or damage to equipment.
Figure 4.9 – Resetting the Serial Converter
Press the UP ARROW or DOWN ARROW key to scroll
through the parameter list. Press the LEFT ARROW or
RIGHT ARROW key to modify parameter values. Press
the ENTER key to save a new value.
5> Reset Module = Reset Module