Rockwell Automation RECOMM-232 Serial Converter for use with DPI AC Drives User Manual
Page 39
Serial Converter Parameters
B-3
No action if set to “Ready.” Resets the DF1 statistical parameters
(numbers 07 to15) to 0 if set to “Clear Counts.” This parameter is a
command. It will be reset to “0 = Ready” after a “Clear Counts”
command has been performed.
Number of DF1 packets sent by the serial converter. The value of
this parameter is normally approximately equal to the value of
DF1 Packets Rcvd (08).
Number of DF1 packets received by the serial converter. The value
of this parameter is normally approximately equal to the value of
DF1 Packets Sent (07).
Number of DF1 messages that were sent but not acknowledged.
1
This value is normally a low value. If it is continually incrementiong and you
are having communications problems, use a lower baud rate or replace
the RECBL-SFC serial cable.
06
Clear DF1 Counts
Range:
0 = Ready
1 = Clear Counts
Default:
0
Type:
Read/Write
07
DF1 Packets Sent
Range:
0 to 4294967295
Default:
0
Type:
Read Only
08
DF1 Packets Rcvd
Range:
0 to 4294967295
Default:
0
Type:
Read Only
09
Undelivered Msgs
1
Range:
0 to 65535
Default:
0
Type:
Read Only