Rockwell Automation RECOMM-232 Serial Converter for use with DPI AC Drives User Manual
Page 41
Serial Converter Parameters
B-5
Number of duplicate messages sent by the serial converter. This
value contains the total number of consecutive messages received
by this device with the same TNS (Transaction Sequence) number.
Auto: Converter will automatically run DPI if connected to a DPI
product.
Data rate used by the DPI host product. This data rate is set in the
drive, and the adapter autobauds to it.
DF1 address actually used by the serial converter.
1
This value is normally a low value. If it is continually incrementiong and you
are having communications problems, use a lower baud rate or replace the
RECBL-SFC serial cable.
15
Duplicate Msgs
1
Range:
0 to 65535
Default:
0
Type:
Read Only
16
(Reserved)
Range:
0 = Auto
Default:
0
Type:
Read/Write
17
DPI Data Rate
Range:
0 = 125 kbps
1 = 500 kbps
Default:
1
Type:
Read Only
18
DFI Addr Actual
Range:
0 to 254
Default:
0
Type:
Read Only