Rockwell Automation RECOMM-232 Serial Converter for use with DPI AC Drives - Manual (Page 2)

Copyright © 2001 Rockwell Automation. All rights reserved.
The information in this manual is subject to change without notice.
Throughout this manual, the following notes are used to alert you to safety
considerations:
Important: Identifies information that is critical for successful application
and understanding of the product.
!
ATTENTION: Identifies information about practices or
circumstances that can lead to personal injury or death,
property damage, or economic loss.
Reliance, SP600, DPI, and VS Utilities are trademarks of Rockwell
Automation.
Trademarks not belonging to Rockwell Automation are property of their
respective companies.
!
ATTENTION: Only qualified electrical personnel familiar with
the construction and operation of this equipment and the
hazards involved should install, adjust, operate, and/or service
this equipment. Read and understand this manual in its
entirety before proceeding. Failure to observe these
precautions could result bodily injury and/or damage to
equipment.
ATTENTION: If the serial converter is transmitting control I/O
to the product (indicated by a solid green diamond LED), the
product may fault when you remove or reset the serial
converter. Determine how your product will respond before
removing or resetting a connected serial converter. Failure to
observe this precaution could result bodily injury and/or
damage to equipment.
ATTENTION: The setting of Comm Flt Action (04) determines
the action of the serial converter and connected product if DF1
serial communications are disrupted. By default, this
parameter faults the product. You can set this parameter so
that the product continues to run. Ensure that the setting of
this parameter does not create a hazard. Failure to observe
this precaution could result bodily injury and/or damage to
equipment.
ATTENTION: DPI host products must not be directly
connected together via RECBL cables. Unpredictable
behavior due to timing and other internal procedures can result
if two or more devices are connected in this manner. Failure
to observe this precaution could result bodily injury and/or
damage to equipment.