Rockwell Automation LX-Series Iron Core Linear Servo Motors - Manual (Page 22)

22 Rockwell Automation Publication LX-UM001A-EN-P - March 2011
Chapter 3 Install the LX-Series Linear Motor
8. On the opposite end of the base, install the first magnet track using
M5 x 0.8 x 16 mm Socket Head Captive Screw (SHCS).
Do not tighten screws.
9. Install additional magnet tracks.
Place each magnet track on the base and slide towards the previously install
magnet track. For correct magnetic polarity the alignment holes should all
be on the same side.
IMPORTANT Use non-magnetic tools and hardware such as beryllium copper,
300 series stainless steel. If not available proceed with care
since ferrous items will be attracted to the magnet tracks.
3
2
Alignment Holes