Rockwell Automation LX-Series Iron Core Linear Servo Motors - Manual (Page 25)

Rockwell Automation Publication LX-UM001A-EN-P - March 2011 25
Install the LX-Series Linear Motor Chapter 3
Mount a Single Coil with a Single Magnet Track
Follow these steps to install a single coil with single magnet track.
1. Install the magnet track by using M5 x 0.8 x 16 mm SHCS.
2. Remove any burrs and clean the motor-coil mounting surface.
3. Install the motor coil under the carriage, by using M5 x 0.8 screws that
extend through the carriage by at least 12 mm (0.5 in.), but no more than
20 mm (0.7 in.).
4. Tighten screws but do not torque them.
5. Slide the carriage assembly onto the bearing pucks.