Rockwell Automation LX-Series Iron Core Linear Servo Motors User Manual
Page 23
![background image](/manuals/581747/23/background.png)
Rockwell Automation Publication LX-UM001A-EN-P - March 2011
23
Install the LX-Series Linear Motor
Chapter 3
10. Move the carriage with motor coil installed over the installed magnet
tracks.
There may be some resistance while moving onto the tracks, this is normal.
11. Measure the gap between the motor coil and magnet track using plastic
shim stock.
The gap should be 0.79 mm (0.031 in.) to 1.70 mm (0.067 in.). If gap is
too large, add a brass or a stainless steel shim between the motor coil and
carriage. If the gap is too small, machine the slide or place shims under the
bearing pucks.
12. Install the remaining magnet tracks in the order shown.
13. Slightly loosen the mounting screws on the exposed magnet tracks.
Do not loosen the magnet tracks that are covered by the motor coil.
Shim
4
5
6