Rockwell Automation LX-Series Iron Core Linear Servo Motors - Manual (Page 24)

24 Rockwell Automation Publication LX-UM001A-EN-P - March 2011
Chapter 3 Install the LX-Series Linear Motor
14. Align the magnet tracks with an aluminum straight edge, and the supplied
alignment tool.
15. Place the alignment tool in the holes on each of the magnet tracks.
16. Align the edges of the magnet tracks with the aluminum straight edge and
tighten the bolts.
17. Position the carriage over the complete sections and continue aligning the
remainder of the magnet tracks.
18. Torque all screws to the values listed in the table, securing assemblies in
place by using all mounting holes.
Aluminum Straight Edge
Alignment Tool
TIP If space limitation prevents the use of an aluminum
straight edge. Place a 0.5 mm (0.020 in.) plastic shim
between the magnet tracks, tighten the bolts, and then
remove the shim
.
SHCS
SHCS Torque
Black Oxide Steel
N•m (lb•ft) Stainless Steel
N•m (lb•ft)
M5 9.5 (7.0) 6.36 (4.7)
ATTENTION: Remove the alignment tool and make certain all
magnet-track mounting hardware is flush or below the magnet
surface to prevent damage to the coil.