Metrohm tiamo 2.3 (process analysis) - Manual (Page 1234)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1218 ￭￭￭￭￭￭￭￭ tiamo 2.3 (for Process Analysis)
Device
Device name
Selection of a device from those available in the device table. The only
devices which shall be offered are those with which the command can
run.
Selection 'Device name' | not defined
Default value not defined
not defined
In this case, the device name must be assigned by the user at the start
of the method.
Device type
Display or selection of the device type. If a device is selected under Device
name, then this Device type field can no longer be edited, and the
device type belonging to the selected device is displayed instead
If the option not defined is selected as Device name, any device types
or device groups which are able to execute the command can be selected,
independently of the devices in the device table.
Selection Device types | 814 USB Sample Processor
Default value 814 USB Sample Processor
Pumps
Tower
Selection of the tower of the Sample Processor for moving to the required
lift position. Both Tower 1 and Tower 2 can always be selected even if the
Sample Processor has only one tower.
Selection 1 | 2
Default value 1
Pump(s)
Selection of the pump that is to be actuated. The pump(s) can either be
built-in or externally connected. With 1+2 both pumps at the selected
tower will be switched at the same time.
Selection 1 | 2 | 1+2
Default value 1
1
Pump 1 is actuated.
2
Pump 2 is actuated.