Metrohm tiamo 2.3 (process analysis) - Manual (Page 457)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.3 (for Process Analysis) ￭￭￭￭￭￭￭￭ 441
￭ SERIES START
Start command for (see Chapter 5.5.2.3, page 432).
￭ SERIES END
Start command for (see Chapter 5.5.2.4, page 433).
￭ EXIT
Start command for (see Chapter 5.5.2.5, page 434).
￭ ERROR
Start command for (see Chapter 5.5.2.6, page 434).
￭ END
End command for all tracks.
5.6.2.2 START
5.6.2.2.1 START - Overview
Dialog window: Method ▶ START ▶ Properties.. ▶ START 'Command name'
Start command for main track.
Appearance
The command has the following appearance:
Parameters
The parameters for the command START are configured on the following
3 tabs:
￭ General
General settings for the method run.
￭ Application note
Writing an application note which is displayed when starting a determi-
nation.
￭ Method variables
Configuring method and sample variables which are to be available for
the method.
Command variables
No command variables are generated in the method run by the START
command.
Method variables
The following method variables are defined in the START command and
can be used in formulas under the designation 'MV.Variable name.Var-
iable designation':