Metrohm tiamo 2.3 Manual - Manual (Page 1017)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.3 ￭￭￭￭￭￭￭￭ 1001
Threshold value
The evaluation of the maximum begins as soon as the slope of the curve
exceeds the set threshold value.
Range 0.1 ... 20.0 °C/s
Default value 1.0 °C/s
5.6.4.8.5 MEAS T/Flow - Additional measured values
Tab: Method ▶ MEAS T/Flow ▶ Properties... ▶ Additional measured values
Command name
Name of the command.
Input 25 characters
A maximum of 6 additional measured values can be defined on this tab
which can then be saved together with the measured values present in
the default settings in additional measured value columns Calculated #
or External # in the measuring point list .
Additional calculated measured values
Additional calculated measured values
on | off (Default value: off)
If this option is enabled, then a maximum of 3 new measured values can
be calculated from existing measured values and saved, which can also be
presented as curves under the designation Calculated 1…3 and used in
formulas as variables 'Command name.CA1…3'.
[New]
Opens the dialog window Calc. measured value # in which the param-
eters for the additional measured value can be entered (see Chapter
5.6.3.11.1, page 927).
[Properties]
Opens the dialog window Calc. measured value # in which the param-
eters for the additional measured value can be edited (see Chapter
5.6.3.11.1, page 927).
[Delete]
Deletes the calculated measured value selected in the table.