Metrohm tiamo 2.3 Manual - Manual (Page 179)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 3 Workplace
tiamo 2.3 ￭￭￭￭￭￭￭￭ 163
Note
The Sample table test is only used to check whether or not all sample
data is correct (in contrast to the Run test (see Chapter 3.6.2, page
128), which also checks the required hardware).
Line
Displays the line number of the currently tested sample data line.
Status displays
One of the following status displays appears underneath the line number:
Selection Sample table test running… | Sample table
test stopped manually | Sample table test fin-
ished without errors | Sample table test fin-
ished with errors
Sample table test running…
This display appears during the test run. A progress bar also appears;
the test can be interrupted thereby by means of the [x] next to the bar.
Sample table test stopped manually
This display appears if the sample table test was canceled manually by
the user.
Sample table test finished without errors
This display appears at the end of a sample table test that has been
completed without errors.
Sample table test finished with errors
This display appears if an error has occurred during the sample table
test. The errors that occured are listed in the Test report field.
Test report
Display of errors that occurred during the sample table test, together with
line numbers.
3.6.4.9.8 Save sample table
Dialog window: Workplace ▶ Sample table / Determination series ▶ [Sample
table] ▶ Save as… ▶ Save sample table
A name for the working sample table to be saved can be entered or selec-
ted in this dialog window.
List of sample tables
The list of sample tables contains information about all the saved sample
tables.