Metrohm tiamo 2.3 Manual User Manual
Page 54
2.4 Formula editor
■■■■■■■■■■■■■■■■■■■■■■
38
■■■■■■■■
tiamo 2.3
Designation
Description
Commands
.CAL
Status of the calibration: 1 = cali-
brated normally, 0 = canceled,
because reference wavelength
was not found.
CAL Spec
.CBY
Command status; 1 = Condition-
ing activated, 0 = Condition-
ing deactivated
SET, KFT, KFC,
BRC
.CLC
Cell constant of the sensor used in
the command (with conductivity
sensors)
MET Cond, MEAS
Cond, CAL Cond
.COD
Coefficient of determination (r
2
),
calculated from calibration func-
tion and confidence interval.
CAL LOOP Opt
.COK
Command status; 1 = Condition
requirement fulfilled, 0 = Con-
dition requirement not fulfil-
led
SET, KFT, KFC,
BRC
.CONC
Concentration of the solution
used for the command
DET, MET, SET,
KFT, STAT, ADD,
DOS, LQH,
STDADD
.CP{#}.MEA
Measured wavelength of the cali-
bration point in nm. If no meas-
ured peak can be assigned, then
not found will be entered.
CAL Spec
.CP{#}.REF
Reference wavelength of the cali-
bration point in nm.
CAL Spec
.CYL
Cylinder volume of the exchange
or dosing unit used for the com-
mand
DET, MET, SET,
KFT, STAT,
STDADD dos,
STDADD auto,
ADD, DOS, LQH,
PREP, EMPTY