Metrohm tiamo 2.3 Manual User Manual
Page 404
4.8 Subwindow Curves
■■■■■■■■■■■■■■■■■■■■■■
388
■■■■■■■■
tiamo 2.3
Selection
● | ╳ | ✸ | ■ | ▲ | no symbol
Default value
no symbol
no symbol
Measuring points are not shown.
Note
With curves, for which the distance between two measuring points is
smaller than 5 pixels, the individual measuring points are not displayed
anymore, even if a symbol has been selected. In this case, the graphics
window can perhaps be enlarged in order to display the symbols again.
Symbol color
Selection of the color for the measuring point symbol.
Selection
13 colors | blue
Default value
blue
Smoothing
Smoothing
on | off (Default value: on)
Activates/Deactivates smoothing for the curve.
Smoothing factor x axis
Factor for smoothing on the x axis.
Range
0.01 ... 1000
Default value
0.01
Smoothing factor y-axis
Factor for smoothing on the y axis.
Range
0.01 ... 1000
Default value
0.01
Show with original curve
on | off (Default value: off)
If this check box is activated, then the original curve (solid line, same
color) will be shown in addition to the smoothed curve (dotted line).