Metrohm tiamo 2.3 Manual - Manual (Page 394)

4.8 Subwindow Curves ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
378 ￭￭￭￭￭￭￭￭ tiamo 2.3
4.8 Subwindow Curves
4.8.1 Curves - General
Subwindow: Database ▶ Curves
Subwindow Curves
The subwindows Curves 1...5 are subwindows in the program part
Database, in which the measuring points generated by the measuring
commands for the focused determination in the Determination table
are shown as a graph. When navigating in the determination overview
this data will be updated automatically (with a certain delay).
The subwindows Curves 1...5 can be switched on in the program part
Database during the definition of the layout and thus made visible. They
can be enlarged and reduced as required; they can also be maximized.
Tabs
In the curve window a tab with the corresponding command name and
the run index (e.g. Chloride.1) is provided for each run of a measuring
command; their sequence is determined by the method.
Display of curves
The curves of the selected determination are shown on the tabs with the
properties defined per window and per command type. The command
type (e.g. DET pH) is shown above the left-hand y axis.
Curves can be zoomed as often as required by spanning a section of the
curve display with the left mouse button pressed down. Zooming can be
undone with a double-click on the section of the graph or with the con-
text-sensitive menu command Show All.
Note
When a new determination is selected the complete curve is always
shown, i.e. the zoom range is not retained when the determination is
changed.
Curves can be copied into the clipboard with the context-sensitive menu
command Copy graphics.
The curves for the command MET Cond and for the evaluation of con-
ductivity are automatically shown with tangents. However, only when
plotting Measured value against Volume or Volume against Meas-
ured value.