Metrohm tiamo 2.3 Manual - Manual (Page 707)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.3 ￭￭￭￭￭￭￭￭ 691
Note
This command is used for rapid routine determinations when the end-
point does not change throughout a series or when an excess of
reagent must be avoided.
Commands
Depending on the measured value one of the following four SET com-
mands can be selected:
￭ SET pH
Potentiometric pH measurement with pH electrodes (measured quan-
tity pH).
￭ SET U
Potentiometric voltage measurement with metal electrodes (measured
quantity voltage U).