Tweco iCNC XT - Manual (Page 17)

iCNC XT
Manual 0-5299 SPECIFICATIONS 2-1
SECTION 2: SPECIFICATIONS
XT2 XT211 XT231 XT242
Processor 2, Intel (secondary processor for motion & I/O)
Operating system XPE
Ram 2GB
Ethernet ports 1 Rj-45
USB ports 3, 2 On backwall (USB2.0) + 1 On door (USB2.0)
Serial ports 2 RS-422/485 ports on d-sub 9 pin
Hard drive 80GB SATA SSD
Operating console Total of 5 switches (does
not have laser pointer
switch)
Total of 17 switches
(includes laser pointer
switch)
Total of 23 switches
(includes laser pointer
switch)
Total of 22 switches
(does not have laser
pointer switch)
Display 15” With touch panel (resistive)
Configuration 1 Plasma 1 Plasma, 1 oxy, 1 pow-
der marker
1 Plasma, 3 oxy, 1 pow-
der marker
2 Plasma, 4 oxy, 1
marker
Number of I/O 7 Relay outputs, 6 inputs 27 Relay outputs, 8 in-
puts
51 Relay outputs, 8 in-
puts
52 Relay outputs, 2x5
inputs
I/O type Line voltage / potential
free outputs
Line voltage or user voltage / potential free outputs Line voltage / potential
free outputs
Axes available 2-3 Y, 1 X, optional 1 iHC Z
Default drives interface Analog +-9V speed signal, incremental encoder inputs
Integrated drives Optional 400W / 750W integrated Yaskawa drives
Integrated plasma height control Optional iHC height control (for up 2 torches)
CNC AC input power volts (amps) 115VAC/230VAC (10A) (without drives 115VAC 3A, 230VAC 1.5A. With drives 115VAC 3A, 230V 10A.)
Drive AC input power volts (amps)
230 VAC (10A)
Cnc protection device 10A slow blow fuse
Optional IO Expander Card with 16 relay outputs available for all iCNC XT models (down draft control)
On XT2 and XT242 all voltage outputs share the same inlet voltage level. There is no inlet for external voltage supply. If internal inlet cable is
removed, external voltage for relay outputs can be connected to line & neutral pins. However, even then all voltage output relays share the same
voltage level (outputs for gas solenoids, lifters etc.
On XT231 and XT211 as a default gas solenoid outputs are configured for inlet voltage output. On output connectectors there are pins for user
voltage that can be used instead if couple of relays are moved on relay card. It is also possible to use different voltage levels for gas solenoids
and gas torch lifter outputs. XT211 and XT231 directly support both ac and dc lifters and common capacitive height controls.