Tweco iCNC XT - Manual (Page 32)

iCNC XT
3-12 INSTALLATION Manual 0-5299
3.10 Oxy Fuel Installation
WARNINGS
DO NOT CONNECT the main power before all wiring is done and all cables are connected from both ends.
Always follow national wiring standard for wire sizes.
This section provides a basic wiring guide for oxy fuel lifter, solenoids and capacitive sensor..
Oxy fuel solenoid wiring
By default the output connector will provide inlet voltage outputs. By moving jumpers on the relay board you have an option to select any dc or
ac voltage. If you choose to use other than inlet voltage you need to provide an external power supply connected to J31/33/34 pins #28 (User
VCC input) and #22 (User GND input).
Voltage selection jumpers explained on following pages.