Tweco iCNC XT - Manual (Page 25)

iCNC XT
Manual 0-5299 INSTALLATION 3-5
3.5 Yaskawa Motor and Servo Installation
The CNC may have a different combination of servo amplifiers. The Yaskawa amplifiers come either as 400W, 750W or a combination of both.
Wiring them is almost the same, the only difference is that the 750W drives has a bigger diameter motor cable so please ensure that the bigger
wattage amplifiers get the thicker cable.
The amplifiers are mounted inside the CNC so that starting from left they go X, Y, Y2 (X is horizontal and Y’s are longitudinal).
Torch
“Y” Limit Switch
“Y” Limit Switch
Gantry
Lifter
“Y”
(+)
(-)
“Y2”
“X”
(-) (+)
(+)
(-)
“Y” is determined by the side with the “Y” limit switches.
“Y2” is the side without the switches.
CUT TABLE