Icnc xt – Tweco iCNC XT User Manual
Page 83
Advertising
iCNC
XT
Manual 0-5299
OPERATION
5-25
5.7.12 Water Switch
• ON position will activate the water spray signal.
• AUTO position will allow the cutting program to command the water spray signal.
• OFF position will prevent activating the water spray from a cutting program.
5.7.13 Ignition Switch
• ON position will activate the ignition signal.
• AUTO position will allow the cutting program to command the ignition signal.
• OFF position will prevent activating the ignition from a cutting program.
Advertising