Tweco iCNC XT - Manual (Page 59)

iCNC XT
Manual 0-5299 OPERATION 5-1
SECTION 5: OPERATION
5.1 Cut Process Screen
Defi nition of areas under the Cut Process Tab shown on the XT CNC Thermal Screen
1
2
3
4
1. Use the drop down boxes to select the material and thickness to be cut.
2. The available cut processes for the selected material and thickness will be displayed along with information indicating which process
is “B” for Best cut quality. “F” for Fastest cut speed. “R” using the robotic consumables for beveling. “M” indicating maximum piercing
thickness. Select the desired process by clicking on the Cut Process number and clicking the “Apply” button. When “Current process”
equals “Selected process” the plasma is ready to cut. If red “Plasma not ready” is on check that the plasma is enabled via a switch
located on the CNC panel.
3. This area shows the consumable to be used for the selected process. Click on “Show Picture” to see a picture of the consumables.
4. This area shows the cutting current and gas pressures that will be used for the selected cutting process.