Tweco iCNC XT - Manual (Page 92)

iCNC XT
5-34 OPERATION Manual 0-5299
5.13 Advanced Setup
The Advanced Setup screen allows the operator the fl exibility to change more parameters if needed. Advanced Setup has several folder tabs
each containing different settings. You can change the tab by clicking it’s title. You can also build a material database of common materials
being cut, and save different speeds and kerf values within each profi le and for each process.
Advanced Setup also has buttons at the bottom of the window. The function of each button is described below.
Plate alignment
Clicking on this button will open ‘Plate alignment’ dialog. See more in chapter Plate Alignment.
General
Allows changes regarding kerf compensation loops. By default this box is checked. On rare occasions the kerf compensation calculation adds
an extra loop which may be undesirable on certain parts with a very small radius. Un-checking this box will remove the loops created.
OK
Clicking the OK button accepts any temporary changes made and returns you to the Parameter Quick View screen.
SAVE
Clicking on Save after a change has been made will cause a password box to appear. After entering the password the changes will become
permanent until changed and saved again.
Close
Clicking on this button will close this screen.