Tweco iCNC XT - Manual (Page 60)

iCNC XT
5-2 OPERATION Manual 0-5299
Other Tabs
1 2 3 4 5
1. CNC & THC tab shows the recommended default parameters the CNC will use for cutting as well as the recommended default param-
eters the Torch Height Control will use during cutting for the process selected.
2. SETUP tab is used to set the length of the hoses from the DMC to the DPC. The default length may be longer then those used in your
particular installation. Press “Refresh” to update the screen with information from the CCM. Setting the correct length will shorten
purge time. DO NOT set the length shorter then the actual hoses used or consumable life will be greatly reduced. This tab also shows
the Cut Chart revision, the selected language and optional dip switch settings at the CCM.
3. CCM / Power Supply tab shows any active or latched power supply faults as well as the CCM fi rmware revision.
4. DMC tab shows any active or latched DMC faults as well as the DMC fi rmware.
5. DPC / Live Values tab shows any active or latched DPC faults, the DPC fi rmware, and the pressures measured at the DPC outlet hoses.