Icnc xt – Tweco iCNC XT User Manual
Page 52
Advertising
iCNC XT
3-32
INSTALLATION
Manual 0-5299
3. Click Edit.
4. Type in your inertia ratio value and click Ok. Example a result of 65 = 65%, 125 = 125%.
5. Disconnect from the drive and repeat steps for Y2 axis.
6. After you are done put the Drive Enable Switch on the front of the controller to “OFF” and remove the USB cable from the drives.
7. Verify all changes have been completed at this point before going to the next step of locking the hard drive.
Advertising