Tweco iCNC XT - Manual (Page 99)

iCNC XT
Manual 0-5299 APPENDIX A-1
APPENDIX:
A.1 Plasma and Height Controller Installation
WARNINGS
DO NOT CONNECT the main power before all wiring is done and all cables are connected from both ends.
Always follow national wiring standard for wire sizes.
This section provides a basic wiring guide for Ultra Cut XT plasma with aouto gas console.
Accesories needed:
- Complete lifter with torch holder and motor
- iHC lifter motor cable 15-50XX (J104 iHCCAB1 - ft.)
- Voltage divider board
- Voltage divider and control wire harness 9-78XX (2 cables)
- Plasma enable and communication cable 12X5042
A.2 Mechanical dimensions iHC
A.2.1 Torch Collision Mounting Bracket
4.92 in. (125mm)
3.35 in.
(85mm)
Height: 85mm [3.35in]
Width: 100mm [3.93in]
Depth: 125mm [4.92in]