Tweco iCNC XT - Manual (Page 23)

iCNC XT
Manual 0-5299 INSTALLATION 3-3
3.2 Main Power
Use a IEC C13 plug to connect the main power to iCNC XT. The main power connector is shown in Section 2.5 Power requirements.
3.3 Limit Switches Wiring
Connect your normally closed limit switches in series as shown in the picture to connector J16 Limits. Y2 alignment switch is used to align the
bridge when homing (optional feature). Mount your Y2 limit so that the bridge is straight when tripping both Y and Y2 limit switches .
3.4 E-stop Wiring
Wire your normally closed E-stop buttons in series to the input. On the power card you have options to enable/disable and change polarity of
the e-stop signals. See next page for jumper descriptions.