Ultra-cut 400 xt – Tweco 400 XT Ultra-Cut Plasma Cutting System With Automated Gas Control User Manual
Page 52
Advertising
ULTRA-CUT 400 XT
3-30
INSTALLATION
Manual 0-5306
Insert Fiber Optic cable here
Art # A-09153_AB
4. Secure each of the thin nuts on the through hole protectors so both nut faces are tight against the sheet metal inside and
out.
5. Plug the Fiber Optic Cable into the PCB as shown below for the DMC-3000. Make sure the locking tabs are engaged.
Plug Fiber Optic cable to/from DPC-3000 here
Art # A-09154
6.
Plug the Fiber Optic Cable into the PCB as shown below for the DPC-3000. Make sure the locking tabs are engaged.
Advertising