Ultra-cut 400 xt – Tweco 400 XT Ultra-Cut Plasma Cutting System With Automated Gas Control User Manual
Page 59
Advertising
ULTRA-CUT 400 XT
Manual 0-5306
INSTALLATION
3-37
3. The Arc Starter must be grounded; the grounding terminal is marked . Refer to the previous section for grounding
details.
Ground Cable
Art # A-04758
1 Nut and 1 Washer
Remain in Place
Torch Leads
4. Use a clamp to secure the Torch Lead Shield braid brass ring to the port on the Remote Arc Starter as shown.
Art # A-04759
Coolant and Pilot Leads
to Torch Valve Assembly
Torch Leads Shield
Shield Clamp
Advertising