Tweco 400 XT Ultra-Cut Plasma Cutting System With Automated Gas Control - Manual (Page 54)

ULTRA-CUT 400 XT
3-32 INSTALLATION Manual 0-5306
Communication Cable to/from
CCM rear of power supply
Ground Cable to/from
“Star” ground on table
Art # A-09157_AC
3.21 Install Remote Arc Starter
Site Location
Select a clean, dry location with good ventilation and adequate working space around all components.
Review the safety precautions in the front of this manual to be sure that the location meets all safety requirements.
Interconnecting cables and hoses attach to the Arc Starter. There must be adequate space around the Arc Starter for these con-
nections without excessive kinking or bending.
Mounting Dimensions
NOTE
Height not shown is 7.375” ( 187mm )
38.10mm
1.50in
190.50mm
7.50in
50.80mm
2.00in
203.20mm
8.00in
50.80mm
2.00in
38.10mm
1.50in Art # A-12058