SARGENT BT- Beacon - Manual (Page 15)

A7974C 15
02/01/13
Copyright © 2009 Sargen
t Manufacturing Company
, an A
SS
A AB
LO
Y G
roup company
. All right
s reser
ved
.
Reproductions in whole or in par
t without express writ
ten permission of Sargen
t Manufacturing Company is prohibited
.
Beacon Exit Device
Installation and Wiring Instructions
FOR INSTALLATION ASSISTANCE CONTACT SARGENT • 1-800-810-WIRE (9473) • www.sargentlock.com
SECTION V: Test Mode Operation
Test Mode Features
Sequence of operation (from Standby Mode):
• Green LED is ON, key switch is operated by rotating fully clockwise (until stop) for >= 5 seconds.
Do NOT overtorque key switch. Green LED flashes 5 times then stays ON.
• Amber LED is OFF, flashes 6 times, ON
• Two high intensity LED’s are OFF, both flash 4 times, then OFF
• Green Laser is OFF, ON for 4 seconds, OFF
CAUTION: Do not stare into laser beam
• Voice messages play: English, Spanish, French
• Voice message: Test Mode Complete
• Green LED remains ON (back to Standby Mode)
SECTION IV: Alarm Mode Operation
Alarm Mode operates according to Dip Switch/Configuration Settings (Section II.4) and NAC/CC Switch
Setting (Section II.5)
1. Upon power up, the Green LED will light (Standby Mode).
2. When alarm is activated via a fire alarm, Beacon will activate.
3. Beacon will respond according to switch settings (see Section II.4) using:
• Flashing high intensity LEDs
• Audible message (Factory programmed)
• Laser (Green)
CAUTION: Do not stare into laser beam
4. Beacon will remain in Alarm Mode until manually reset by the cylinder (keyswitch rotated fully clockwise to
stop for >= two (2) seconds) or after power/alarm reset.
5. Upon reset, Beacon will return to Standby Mode/Ready State.
White
High-Intensity
LED Speaker
Green
Ready-State
LED
Green
Laser
Amber
Diagnostic
LED
Cylinder White
High-Intensity
LED