SARGENT BT- Beacon - Manual (Page 17)

A7974C 17
02/01/13
Copyright © 2009 Sargen
t Manufacturing Company
, an A
SS
A AB
LO
Y G
roup company
. All right
s reser
ved
.
Reproductions in whole or in par
t without express writ
ten permission of Sargen
t Manufacturing Company is prohibited
.
Beacon Exit Device
Installation and Wiring Instructions
FOR INSTALLATION ASSISTANCE CONTACT SARGENT • 1-800-810-WIRE (9473) • www.sargentlock.com
Trouble Conditions and Corrective Actions
Fault Condition Fault Corrective Action
Blink Amber trouble LED
using repeating Blink *1
pattern.
*A 1 second blink with a 5
second pause.
Input power under
16VDC** Correct input voltage to 24VDC (nominal);
(operates from 16-33VDC)
Blink Amber trouble LED
using repeating Blink 2*
pattern.
*Two 1 second blinks with a
5 second pause.
Laser over current
condition** Replace Beacon Insert Assembly
Blink Amber trouble LED
using repeating Blink 3*
pattern.
*Three 1 second blinks with
a 5 second pause.
Motor over current
condition** Replace Beacon Insert Assembly
Blink Amber trouble LED
using repeating Blink 4*
pattern.
*Four 1 second blinks with
a 5 second pause.
Invalid DIP switch
configuration
All DIP switches are OFF**
Refer to DIP Switch Setting/Configuration
Section II.4 for valid switch selections.
Blink Amber trouble LED
using repeating Blink 5*
pattern.
*Five 1 second blinks with a
5 second pause.
Key switch stuck error**
If key switch is detected as
turned for >= 30 seconds.
Inspect operation of cylinder cam with
Beacon plastic switch actuator.
Free possible obstruction or replace
Beacon Insert Assembly if inoperable.
** Disables all audible and visual notification alerts.