Installing a keylinx with an audio port, Installing an irlinx in a keylinx configuration, Installing a keylinx with an audio port -3 – ClearOne NetStreams DigiLinX Dealer User Manual
Page 273: Installing an, Installing an irlin x in a keylinx configuration
KeyLinX
12-3
All specifications subject to change without notification. All rights reserved. Copyright © 2008 NetStreams
Main +1 512.977-9393 / fax +1 512.977.9398 / Toll Free Technical Support +1 866-353-3496
3600 W. Parmer Lane, Suite 100; Austin, TX 7872
EIM dongle (includes one CAT5 cable)
tools for making cable (including cable tester).
Installing a KeyLinX with an Audio Port
The following procedures show you how to install a KeyLinX with an audio port
configuration.
1.
Connect the KeyLinX to the KeyLinX-labeled connector on the splitter.
2.
Connect the Audio Port and/or MU290 to the audio connector on the EIM splitter.
(see Figure 12-3).
Figure 12-3
KeyLinX Installation Drawing
Installing an IRLinX in a KeyLinX Configuration
The EIM splitter is required in all KeyLinX installations. This provides a port for the
KeyLinX (KL101 or KL201) and for the Audio Port. Figure 12-3 shows a KeyLinX