Creating and saving projects, Creating a new project, Discovering devices – ClearOne NetStreams DigiLinX Dealer User Manual
Page 37: Chapter 3, Creating and saving projects -1, Creating a new project -1, Discovering devices -1
Creating and Saving Projects
3-1
All specifications subject to change without notification. All rights reserved. Copyright © 2008 NetStreams
Main +1 512.977-9393 / fax +1 512.977.9398 / Toll Free Technical Support +1 866-353-3496
3600 W. Parmer Lane, Suite 100; Austin, TX 7872
Chapter
3
Creating and Saving Projects
A project is a file (saved with an extension of .nsp) that contains all of the settings for
each of the devices in a system. A dealer can use the DigiLinX Dealer Setup program
to create a project that is specific to each home that has a NetStreams system.
For example, you can name a project “John Doe” and transfer it to the home system
after the hardware has been installed. You can create a project while you're connected
to a DigiLinX system or in the comfort of your own office.
NOTE:
Procedures vary slightly depending on whether or not you are connected to the
DigiLinX network at the time you create the project. Following the Setup
Wizard is the best way to prevent errors in project creation.
Creating a New Project
This section covers the processes involved in creating a new DigiLinX project.
Discovering Devices
To begin a project while connected to the DigiLinX network, the software must locate
all attached devices. To discover devices, complete the following steps:
1.
From the Dealer Setup Wizard, select Continue from the lower left-hand corner of
the window.
The Update StreamNet Devices screen displays if you are connected to the
DigiLinX network (see Figure 3-1). This screen locates all devices connected to
the network.