Configuring the home network and digilinx, Configuring the home network and digilinx -17 – ClearOne NetStreams DigiLinX Dealer User Manual
Page 33
Installing and Running DigiLinX Dealer Setup
2-17
All specifications subject to change without notification. All rights reserved. Copyright © 2008 NetStreams
Main +1 512.977-9393 / fax +1 512.977.9398 / Toll Free Technical Support +1 866-353-3496
3600 W. Parmer Lane, Suite 100; Austin, TX 7872
Figure 2-22
Building a DigiLinX IP Network (3 of 5)
Notice that the address for the home network does not match the IP address scheme for the DigiLinX
network. Left this way, the DigiLinX network would work independently of the Home network, but
the home network would not be able to control the DigiLinX system.
Configuring the Home Network and DigiLinX
To change the IP range for DigiLinX so that it matches the home network’s IP address range, refer to
Figure 2-22. In this example, the home network has a subnet of 255.255.255.0. This means that all
addresses on the home network must use the same numbers in the first three octets. In this case, all IP
address must start with 192.168.1 and the final octet must be unique. To make DigiLinX work with
this network all devices on the DigiLinX network must also start with 192.168.1 and the fourth octet
must also be unique.
To change the system IP address range and subnet range, complete the following steps:
1.
With the system live, highlight System-A/V Distribution from Dealer Setup.
2.
Select Advanced Options.
System information displays (see Figure 2-23).
Laptop
10.153.5
255.0.0.0
MediaLinX
10.15.30.26
255.0.0.0
SpeakerLinX
10.15.18.21
255.0.0.0
SpeakerLinX
10.15.11.29
255.0.0.0
SpeakerLinX
10.15.33.5
255.0.0.0
PC
192.168.1.3
255.255.255.0
PC
192.168.1.4
255.255.255.0
Media Server
10.15.100.110
255.0.0.0
10.15199.225
255.0.0.0
TouchLinX
10.15.30.25
255.0.0.0
Router/
Switch
192.168.1.1
255.255.255.0
IP Camera