Bio-Rad Gene Pulser Xcell™ Electroporation Systems - Manual (Page 25)

3.3.6 Saving a program from Manual Operation
A protocol created in manual mode may be saved as a User Protocol as follows.
• Create a protocol as described in Section 3.3.2, 3.3.3 or 3.3.4.
• With the Protocol Detail screen open, press Save.
• The first User Directory screen will appear (Figure 3.9); the second line will read “Choose location
for protocol”.
• Use the Right and Left Arrow keys to toggle between the two User Directory screens. Press 1–12
or use the Up and Down Arrow keys to highlight the User Name under which to store the protocol.
Press Enter to select the User Name. The User Protocols screen will appear (Figure 3.10); the
second line will read “Choose location for protocol”. If it is necessary to create a new User Name,
see Section 3.5.2.
• Use the Right and Left Arrow keys to toggle between the two User Protocols screens. Press 1–12
or use the Up and Down Arrow keys to highlight a location for the new protocol. A protocol may
be stored in a position without an entry (see Section 3.3.6A) or in a position with an entry (see
Section 3.3.6B). If necessary, delete a User Protocol as described in Section 3.5.5.
• To use the saved protocol, press Enter to view the Protocol Detail screen. Press the Pulse button
to electroporate the sample.
User Directory screen
Fig. 3.9. User Directory screen. This is an example of the first User Directory screen. Toggle
between this screen and the second screen with Users 7–12 using the Left and Right Arrow keys.
When purchased, the initial User Directory screen will have only numbers without any names.
19
U S E R D I R E C T O R Y
C h o o s e l o c a t i o n f o r p r o t o c o l
1 . U s e r 1
2 . L a b g u y
3 . M a l c o m
4 . S m i t h
5 . W e s s o n
> 6 .