Bio-Rad Gene Pulser Xcell™ Electroporation Systems - Manual (Page 9)

Warning: The Gene Pulser Xcell generates, uses, and radiates radio frequency energy. If it is not used in
accordance with the instructions given in this manual, it may cause interference with radio communications.
The Gene Pulser Xcell has been tested and found to comply with the limits for Class A computing devices
(pursuant to Subpart J of Part 15 of FCC Rules) which provide reasonable protection against such
interference when operated in a commercial environment. Operation of this equipment in a residential area
is likely to cause interference. In this case the user will be required, at their expense, to take whatever
measure may be required to correct the interference.
Section 2
Unpacking and System Installation
The Gene Pulser XCell™ can be purchased as three systems as well as component parts:
165-2660 Gene Pulser Xcell Total System for eukaryotic and microbial cells, 100–240 V, 50/60
Hz, exponential decay and square wave delivery, includes main unit, CE Module, PC
Module, ShockPod, 15 sterile cuvettes (5 each of 0.1, 0.2, and 0.4 cm gap),
instruction manual
165-2661 Gene Pulser Xcell Eukaryotic System, 100/240 V, 50/60 Hz, exponential decay
(25–3,275 µF range) and square wave delivery, includes main unit, CE Module,
ShockPod, 5 sterile cuvettes (0.4 cm gap), instruction manual
165-2662 Gene Pulser Xcell Microbial System, 100/240 V, 50/60 Hz, exponential decay and
square wave delivery, includes main unit, PC Module, ShockPod, 10 sterile cuvettes
(5 each of 0.1 and 0.2 cm gap), instruction manual
165-2666 Gene Pulser Xcell main unit, 100/240 V, 50/60 Hz
165-2667 Gene Pulser Xcell CE Module, 25–3,275 µF range controlled by main unit, includes
integral leads, 5 sterile cuvettes (0.4 cm gap), instruction manual
165-2668 Gene Pulser Xcell PC Module, 50–1,000 ohm range controlled by main unit, includes
integral leads, 10 sterile cuvettes (5 each of 0.1 and 0.2 cm gap)
165-2669 Gene Pulser Xcell ShockPod shocking chamber, includes integral leads for connection
to Gene Pulser Xcell, Gene Pulser II, or MicroPulser
2.1 Unpacking the System Components
Remove all packing material and connect components on a flat, dry surface near an appropriate
electrical outlet.
Upon receiving your instrument, please check that all items listed were shipped. If any items are missing
or damaged, contact your local Bio-Rad office.
3