Garmin GNS 430 - Manual (Page 187)

179
Appendix A: NavData Card Use
The Jeppesen NavData® card supplied with your GNS 430 can be installed or
removed when the GNS 430 is on or off. Insert the card with the swing arm handle at the
bottom and the label facing to the left (see illustration right). If the NavData card is not
present when the unit is turned on, you will receive a “No Jeppesen Aviation Database
- Limited to user defi ned waypoints” message on the database confi rmation page. If the
NavData card is removed during operation, a “Data card removed-Unit will restart in
30 seconds” warning. A counter will begin to count down and, if the card is not replaced
within 30 seconds, the GNS 430 will automatically reinitialize. You may also reinitialize
the unit manually by pressing E.
To insert the NavData card:
1a. Place the card into the NavData card slot, with the label facing to the left and the swing arm
handle at the bottom front.
2a. Press the NavData card into place until it seats on the internal connector and the front of the
card is flush with the face of the GNS 430 unit.
3a. If the swing arm handle is up, gently lower the handle and push it into place—flush with the
face of the GNS 430 unit.
To remove the NavData card:
1b. Gently press on the tab—using a slight upward motion—at the front center of the NavData card.
This will partially deploy the swing arm handle.
2b. Rotate the swing arm handle upward (and outward) until it locks into place, perpendicular to the
face of the GNS 430 unit.
3b. Grasp the top and bottom surfaces of the swing arm handle, between your thumb and fore-
finger, and pull directly away from the face of the GNS 430 unit to unseat the connector and
remove the NavData card.
NOTE
There are two data card slots on the face of the GNS 430. The Jeppesen
NavData® card should be inserted in the left-most slot. The second slot is pro-
vided for future options and expansion capabilities.
NAVDATA ®
CARD USE
A APPENDIX
o
b
n
b
p
b
190-00140-00.indd 179 5/7/2003, 5:18:44 PM