Direct to – Garmin GNS 430 User Manual
Page 61
53
Cancelling Direct-To Navigation
Once a direct-to is activated, the GNS 430 will provide navigation guidance to the
selected destination until the direct-to is replaced with a new direct-to or flight plan,
cancelled, or the unit is turned off.
To cancel a direct-to:
1. Press the
D
key to display the select direct-to waypoint page.
2a. Press
m
to display the direct-to options menu.
3a. With “Cancel Direct-To NAV?” highlighted, press
E
. If a flight plan is still active, the GNS
430 will resume navigating the flight plan along the closest leg.
Specifying a Course to a Waypoint
Whenever you perform a direct-to, the GNS 430 will set a direct great circle course
to your selected destination. You can also manually defi ne the course to your destination,
using the “CRS” course fi eld on the select direct-to waypoint page.
To manually define the direct-to course:
1. Press the
D
key.
2b. Use the small (
a
) and large (
d
) right knobs to select the destination waypoint.
3b. Press
E
to confirm the selected waypoint, then rotate the large right knob (
d
) to highlight
the course (“CRS”) field.
4. Rotate the small (
a
) and large (
d
) right knobs to select the desired course and press
E
.
5. Press
E
again to begin navigation using the selected destination and course.
6. To reselect a direct course from present position (or select a new manually-defined course),
simply press
D
, followed by
E
twice.
3
DIRECT TO
Cancelling &
Manual Course
q
p
b
o
a
p
a
190-00140-00.indd 53
5/7/2003, 5:16:50 PM