Dell PowerEdge RAID Controller H700 - Manual (Page 124)

124 Security Key and RAID Management
Change Key
NOTE: Change Key is active if there is a security key present on the controller.
Perform the following steps when changing the security key on the controller:
1 During host system bootup, press <Ctrl><R> when the BIOS screen is
displayed.
The
Virtual Disk Management screen is displayed.
If there is more than one controller, the main menu screen is displayed.
2 Select a controller, and press <Enter>.
The Virtual Disk Management screen is displayed for the selected
controller.
3 Use the arrow keys to highlight Security Key Management.
4 Press <F2> to display the actions you can perform.
5 Select Change Key and press <Enter>.
6 The Change Security Key screen is displayed. The cursor is at the Security
Key Identifier. Enter an identifier for your Security Key.
7 Press <Tab> to enter a new passphrase.
NOTE: You must provide the current passphrase in order to change the
security key on the controller.
8 Press <Tab> and select OK to accept the settings and to exit the window.
Select Cancel to exit if you do not want to change the security key on the
controller.
NOTE: If there is an existing configuration on the controller, it is updated
with the new security key. If you had previously removed any secured disks,
you still need to supply the old passphrase to import them.
PERC7.2_UG.book Page 124 Thursday, March 3, 2011 2:14 PM