Dell PowerEdge RAID Controller H700 - Manual (Page 78)

78 Driver Installation
Installing the RPM Package With DKMS Support
Perform the following steps to install the RPM package with DKMS support:
1 Uncompress the gzipped tarball driver release package.
2 Install the DKMS package using the command: rpm –ihv dkms-
<version>.noarch.rpm
3 Install the driver package using the command: rpm –ihv
megaraid_sas-<version>.noarch.rpm
NOTE: Use rpm -Uvh <package name> when updating an existing package.
4 If the previous device driver is in use, you must reboot the system for the
updated driver to take effect.
5 Verify that the driver has been loaded with the following system
commands: modinfo megaraid_sas and dkms status.
Upgrading the Kernel
When upgrading to a new kernel, you must reinstall the DKMS-enabled
driver packages. Perform the following steps to update or install the driver for
the new kernel:
1 In a terminal window, type the following:
dkms build -m <module_name> -v <module version>
-k <kernel version>
dkms install -m <module_name> -v <module version>
-k <kernel version>
2 To check whether the driver is successfully installed in the new kernel, type:
dkms status
You see a message similar to the following one:
<driver name>, <driver version>, <new kernel
version>: installed
3 If the previous device driver is in use, you must reboot the system for the
updated driver to take effect.
PERC7.2_UG.book Page 78 Thursday, March 3, 2011 2:14 PM